Controlled Products Systems Group CSL24VH - Manual (Page 26)

24
The basic installation is complete.
INSTALL THE COVER
FINISH INSTALLATION
INSTALL THE COVER
TO INSTALL THE COVER
1
Align the tabs on the rear cover with the slots on the chassis and place the
cover over the operator.
2
Secure both sides of the rear cover to the chassis with two 5/16-18 hex bolts
and washers.
3
Align the front cover with the back cover, making sure the grooves line up.
4
Secure the front cover to the chassis with two 5/16-18 hex bolts and washers.
5
Secure the front cover to the rear cover using the 5/16-18 screw.
The operator cover consists of two pieces: a rear cover and a front cover. The front cover can easily be removed to access the electrical box. To access the reset switch slide the
access door up. The front cover and access door can be locked with the key.
TO LOCK THE ACCESS DOOR
From the factory the access door for the reset switch will not be locked. To lock the
access door follow the steps below:
1
Locate the lock tab on the back of the front cover and remove the screw
securing the tab to the cover.
2
Turn the tab 180 degrees, then secure with the screw. The access door can
now be locked.
Tabs on Rear Cover
Slots on Chassis
Groove on Front Cover
5/16-18
Hex Bolts
and Washers
5/16-18
Screw
Access Door
Lock Tab
Factory Default position (back of front cover)
Access Door