Controlled Products Systems Group CSL24VH User Manual
Page 13
11
SITE PREPARATION
VEHICLE LOOPS
The vehicle loops allow the gate to stay open when vehicles are obstructing the
gate path. Suggested for vehicles 14 feet (4.27 m) or longer. Vehicle loops are
not required but are recommended.
!
!
Conduit must be UL approved for low and high voltage. Consider the operator
placement BEFORE installing the pad or post.
Entrapment protection devices are required to protect against any entrapment
or safety conditions encountered in your gate application (refer to page 5 for
more details). Install warning signs on both sides of the gate.
Proper grounding gives an electrical
charge, such as from an electrical static
discharge or a near lightning strike, a
path from which to dissipate its energy
safely into the earth. Without this path,
the intense energy generated by
lightning could be directed towards the
gate operator. Although nothing can
absorb the tremendous power of a direct
lightning strike, proper grounding can
protect the gate operator in most cases.
(Inside Property)
Warning Signs
Check national and local
codes for proper depth
Concrete Pads
SAFETY
EARTH GROUND ROD
CONDUIT & CONCRETE PAD
TYPES OF INSTALLATIONS
!
!
STANDARD INSTALLATION
REAR INSTALLATION
The illustration is an example of a standard installation.
The illustration is an example of a rear installation.
(Inside Property)
(Inside Property)
Gate Rail Stop
Gate Rail Stop
Gate Rail Stop
Gate Rail Stop