Controlled Products Systems Group CSL24VH - Manual (Page 37)

35
INPUT LEDS
OPEN INPUT OFF Input inactive
ON Input active
BLINK Input active on other operator
CLOSE INPUT OFF Input inactive
ON Input active
BLINK Input active on other operator
STOP INPUT OFF Input inactive
ON Input active
BLINK Input active on other operator
FIRE DEPT
INPUT
OFF Input inactive
ON Input active
BLINK Input active on other operator
OPEN SAFETY
INPUT
OFF Input inactive
ON Input active
BLINK Input active on other operator
CLOSE SAFETY
INPUT
OFF Input inactive
ON Input active
BLINK Input active on other operator
STATUS LEDS
INPUT POWER OFF OFF state
ON AC charger or Solar power available
BATT
CHARGING
OFF Not charging
ON Trickle charge
FAST BLINK High current charge
FASTER BLINK Over voltage error
TIMER OFF The timer is disabled
ON The timer is enabled
MEDIUM BLINK The timer is running
FAST BLINK The timer is paused
FASTER BLINK The timer is cancelled
GATE MOVING OFF The gate is stopped
ON The gate is opening or closing
FASTEST BLINK The operator is in E2
BATT LOW OFF No battery error
ON Battery low error
MEDIUM BLINK Battery critically low error
FAST BLINK Battery disconnected error
FASTEST BLINK Charging, extreme temperature, or over
voltage error
ACC PWR OVLD OFF OFF state
ON Accessory overload protector opened
CONTROL BOARD LEDS
TROUBLESHOOTING
CONTROL BOARD LEDS
YELLOW DIAGNOSTIC LED
# BLINKS MEANING CORRECTION
1 BLINK Low Power Mode (not an error)
2 BLINKS ID resistor failure Check ID resistor wiring, clear limit
settings and reset limits
3 BLINKS Exceeded Maximum
Run Timer
Check gate travel, if necessary adjust
force setting
5 BLINKS RPM (obstruction) Check for obstruction, if necessary
adjust force setting
6 BLINKS Current (obstruction) Check for obstruction, if necessary
adjust force setting
7 BLINKS Position failure Check gate travel, clear limit settings
and reset limits
12 BLINKS Loop Error One of the loops is in error. Refer to the
loop detector to determine the error.
RED DIAGNOSTIC LED
# BLINKS MEANING CORRECTION
2 BLINKS Current Sense Motor control circuit fault, replace
control board
3 BLINKS FET Failure Motor control circuit fault, replace
control board
4 BLINKS RAM Failure Memory failure, replace control board
5 BLINKS Flash Memory
Failure
Memory failure, replace control board
6 BLINKS EEPROM Failure Memory failure, replace control board
7 BLINKS Watchdog Failure Controller failure, replace control board
8 BLINKS Brownout Check power harness or line voltage
9 BLINKS Fail Control Board failure
10-14 BLINKS Software Failure Cycle power to the control board. If
continues replace control board.
DIAGNOSTIC CODES LEDS