Impulse 520W User Manual
Page 27
Host PC Configuration Tab (continued)
To communicate with a SeaDAC Lite module, select “SeaDAC Lite” from the “COM
Port” dropdown box. MAXSSD will search for any SeaDAC Lite modules
connected to a USB port and display them in a frame (as shown below). A new
“Digital I/O” tab will appear. If more than one SeaDAC Lite module is connected,
select the one you want to test from the list and click the “Digital I/O tab”. You can
use this new tab to test the functionality of inputs and relay outputs. The “Digital
I/O” tab is covered in detail on subsequent pages.
To communicate with a SeaI/O Ethernet or Wireless 802.11b/g module, select
“ETHERNET” from the “COM Port” dropdown box. When Ethernet is selected,
MaxSSD searches for any SeaI/O Ethernet or Wireless modules on the network and
displays their IP addresses in the “Available Ethernet Devices” list box (not shown).
When an IP address is selected from the list box, a socket is opened to the SeaI/O
module and it is ready for communication.
NOTE:
If no IP address is shown when using Ethernet modules, review the
previous Hardware Configuration section, or proceed to the
Troubleshooting section at the end of this manual.
© Sealevel Systems, Inc.
- 24 -
SeaI/O User Manual