Impulse 520W - Manual (Page 51)

Configuring a Wireless Module (Continued)
Now that you can communicate with the wireless SeaI/O module, the Wireless
Configuration settings window will open, as shown.
You can now change the Network SSID, Topology, Channel, and Security Settings to
match your wireless network. After making your changes and clicking OK, the
device will reboot and take 20 seconds to appear on the network using your new
settings. If you change the SSID and/or network Topology and/or Channel, you’ll
have to reconnect to the SeaI/O module. Close Ethernet Config for now.
The supported wireless configuration settings are detailed on the following page.
NOTE: The Network SSID, wireless network channel, and security settings
are specific to your wireless network. Consult your IT department if
you are unsure of your wireless network settings.
NOTE: IMPORTANT! Once you change the wireless configuration and
click the OK button, the wireless SeaI/O module will disappear
from the Ethernet Config window. The SeaI/O module will now be
configured to work with your wireless network, but will likely be on
a different subnet. You still need to configure the Device Network
Settings before the module will work with your wireless network.
© Sealevel Systems, Inc. - 48 - SeaI/O User Manual