Impulse 520W User Manual
Page 62
Step 4
Remove the three screws from the bottom of the
module and remove the front plate.
Step 5
Install up to four industry standard ribbon cables
in the 50-pin header connectors. A list of optional
cable part numbers is listed on the previous page.
Step 6
Replace the front plate and install the three screws
in the bottom of the module as shown.
Step 7
Replace the metal strain relief. Start both screws
and tighten only until snug. Do not over-tighten.
Step 8
Replace the top half by starting it on the left side
over the connectors and then snapping the right
side down into place. Be careful not to pinch
fingers. Replace both screws on each side and
then replace the terminal block on the left side.
Step 9
Continue with the installation of the SeaI/O-463
module. The SeaI/O Hardware Description
section of this manual contains information on
TTL applications and optional accessories. The
SeaMAX Application Suite section walks you
through setting up the hardware address (Slave ID)
and software installation.
© Sealevel Systems, Inc.
- 59 -
SeaI/O User Manual