Impulse 520W - Manual (Page 55)

Configuring a Wireless Module (Continued)
To complete the configuration, you need to change the IP Address of your wireless
adapter back to its original settings. Open the Network Connections utility (Start Æ
Settings Æ Network Connections). Right-click on your network adapter and select
Properties.
On the General tab, select ‘Internet Protocol (TCP/IP)’, leaving the box checked, and
then click the Properties button.
In the Internet Protocol (TCP/IP) Properties window, change the settings for your
wireless adapter back to the original settings you noted at the beginning on this
section. Click the OK button in this window. Click the OK button on the Wireless
Network Connection Properties window.
Your wireless adapter should now be configured for your wireless network and the
wireless SeaI/O module should now be properly configured to work with your
wireless network. You can open Ethernet Config to verify. If you have any
problems, please contact Sealevel technical support at
[email protected] .
© Sealevel Systems, Inc. - 52 - SeaI/O User Manual