Impulse 520W User Manual
Page 57
Configuring a Wireless Module (Continued)
Set the slave ID of the “base” wireless SeaI/O module using the rotary switch or
software selection method discussed in the Setting Device Address section
(MaxSSD chapter) of this manual. This guarantees that any expansion modules
connected next will not conflict with the “base” module. Perform another Get
operation to verify that you can communicate with the “base” wireless SeaI/O
module at the new slave ID.
NOTE:
Configure the SeaI/O modules one at a time. Set the address to a
hardware slave ID other than “0” or a software slave ID other than
247, to avoid device conflicts during setup.
After the “base” wireless SeaI/O module is successfully communicating via
MaxSSD, you can proceed with adding SeaI/O expansion modules (N-series). Refer
to the Configuring Expansion Modules section of this manual.
© Sealevel Systems, Inc.
- 54 -
SeaI/O User Manual