Impulse 520W - Manual (Page 54)

Configuring a Wireless Module (Continued)
Open the Wireless Network Connection utility again (Start Æ right-click on My
Network Places Æ select Properties from the menu. In the next window, right-click
on your wireless network connection Æ select ‘View Available Wireless Networks’
from the menu).
Select the SSID for your wireless network and click the “Connect” button. The
wireless SeaI/O module will no longer be visible since you configured it to work with
your wireless network in the previous step. You still need to configure the ‘Device
Network Settings’ in Ethernet Config to complete the configuration of the wireless
SeaI/O module.
Open Ethernet Config (Start Æ All Programs Æ Sealevel SeaMAX Æ Ethernet
Config). The wireless SeaI/O module should appear in the ‘Available SeaI/O
Devices’ pane. Click on the wireless SeaI/O module to select the device. The
current settings now appear in the ‘Device Network Settings’ area.
If your wireless network is set up to use DHCP, click the ‘enable DHCP
configuration’ checkbox and then click the ‘Apply Changes’ button.
Otherwise, set the IP Address, Network Mask, and Gateway to match the settings for
your wireless network. You can change the ‘Device Name’ to something appropriate
for your application. Click the ‘Apply Changes’ button. The wireless SeaI/O module
will again disappear, but is now fully configured to work with your wireless network.
Close the Ethernet Config utility.
© Sealevel Systems, Inc. - 51 - SeaI/O User Manual