Impulse 520W User Manual
Page 50
Configuring a Wireless Module (Continued)
To confirm that the IP Address for your wireless adapter was changed successfully,
reopen Ethernet Config (Start Æ All Programs Æ Sealevel SeaMAX Æ Ethernet
Config).
You should now see the wireless SeaI/O module’s ‘Name’ listed (“DemoUnit” in this
example). This indicates that your wireless adapter and the wireless SeaI/O module
are on the same subnet and you are now able to communicate with the wireless
SeaI/O module.
NOTE:
IMPORTANT!
Do not make any changes to the ‘Device Network Settings’ at this
point. You must complete the Wireless Configuration first.
Verify that you can communicate with the wireless SeaI/O module by clicking the
“Wireless Configuration” button.
© Sealevel Systems, Inc.
- 47 -
SeaI/O User Manual