Luminex xPONENT 3.1 - Manual (Page 53)

41
Touring the Software
protocol. The functionality of the tabs you see while configuring the replay batch is the
same as described in “Batches Tab” on page 16.
Open. Opens the Results tab. Use this tab to view the saved batch results for the
selected batch.
Results Tab
FIGURE 23. Results Tab
The Results tab has the same Save Image, Progress, and Well Report buttons as the
Current Batch tab. For more information about these buttons, see “Current Batch Tab” on
page 34. The following buttons are added to the Results tab:
• Formula - Opens the Change Analysis dialog box with a list of analytes used in the
batch. Click an analyte to open the Analysis Settings dialog box from which you can
select a new analysis setting for the analyte. For more information, see “Analysis
Settings Dialog Box” on page 28.
• Approve - Opens the Batch Approval Confirmation dialog box, which contains the
data for analytes selected in the Results tab. Click Yes to approve the batch. The
dialog box confirms the approval.
• Validate - Validates an entire selected row or cell in the Results table. Average rows or
cells cannot be selected. If you haven’t selected an item or the item you selected does
not need to be validated, a warning dialog box displays.
• Invalidate - Invalidates an entire selected row or cell in the Results table. The
selection will turn red when invalidated. Select the same item and click Validate to
remove the invalidation status.
• Save - Saves the batch. This button only appears if a change has been made to the
batch.