DoorKing Remote Account Manager - Manual (Page 24)

SECTION 3 – SYSTEM MANAGEMENT
Once an account(s) has been created, the access control system information must be programmed. This
information includes setting the entry system parameters, labeling the system relays for each entry point, using
or ignoring card (access device) facility codes, mass enabling device (card, transmitter, etc.) codes, creating
security levels and time zones, creating hold open times, creating a holiday schedule and programming the
elevator control parameters if elevator control is used.
The control board series that was chosen when you first created an account (2.1.2) will affect how the entry
panel is programmed. This chapter and the illustrations in it, addresses programming an entry panel with a 30
Series control board. If you are programming an entry panel with the Enhanced 40 Series board, refer to version
5.6 of this manual.
3.1 Entry Panel Programming
The first step in system management is to program the entry panel system parameters. The entry panel can be a
model 1833, 1834, 1835, 1837 or 1838 depending on your specific needs. The Remote Account Manager
software is designed to address all of these entry panels, therefore some programming steps will be slightly
different for the different panels.
1. On the account screen, select the account that you want to program the system information for by
clicking on the account name, or selecting it from the accounts listed in the sidebar.
2. From the sidebar, click the + sign next to the account folder, then click the System folder to display
the System Information screen. You can also navigate to this by selecting View and then Accounts
(Fig 9).
Figure 9
Page 24 1835-066-N-7-13