DoorKing Remote Account Manager - Manual (Page 31)

3.3 Relay Hold Open Time Zone Programming
Up to seven (7) relay hold time zones can be created in the software. The eighth time zone is labeled HOL and is
used with the Holiday Schedule. After the time zones have been created, they can then be applied as needed to
the system relay(s) that you chose.
NOTE: The time zones applied to the Tracker™ board relays (system relays 3-18) are only accurate to 5
minutes.
3.3.1 Creating Relay Hold Time Zones
Click the HOLD OPEN button on the tool bar to bring up the Relay Hold Open Times screen (Fig 20).
1. Enter a Begin Time and an End Time for the first time zone.
2. Click the day(s) of the week that the time zone is to be active (a check will appear in the box).
3. Repeat the above to create up to seven additional time zones. NOTE: Time Zones may
overlap.
4. Click CANCEL to return to the System Info screen without saving the time zones, or click the
CLEAR button to reset the table and start over.
5. Go to Section 3.3.2 to apply the time zones to the desired system relays, or click OK to save
the time zones and return to the System Info screen without applying the time zones to any
relay.
Figure 20
1835-066-N-7-13 Page 31