DoorKing Remote Account Manager - Manual (Page 34)

3.5 Security Levels
Security Levels (SL) allow you to control individual access through the controlled entry points by persons using a
wiegand device (card, transmitter, PIN, etc.). As an example of this, a plant manager may have 24 hour, seven
day a week access into the plant, but individual workers will only be granted access depending on which shift
that they work. It is also possible to allow a person 24 hour a day access at one entry point, but limit their access
at another entry point. This is possible because each security level can have up to four different time zones
created. Note: Security levels do not apply to Model 1834.
Individuals can only be assigned a single security level (see sect 4), however there are 31 different security
levels available. The first two security levels are factory set and cannot be changed. SL00 disables all devices
(cards, transmitters, etc.) assigned to an individual. An example of using SL00 would be for an individual who
has been evicted from an apartment, or an employee who has been fired from a job, and they are no longer
granted access at any entry point. In effect, SL00 "turns off" all devices assigned to that individual. The opposite
of SL00 is SL01, which enables all devices assigned to an individual on a 24 hour a day, 7 day a week basis. An
example of using SL01 would be for management or maintenance personnel who need access at all entry points
at all times.
The remaining 29 Security Levels (SL02 - SL30) can each have up to four (4) Time Zones (TZ) created within
them allowing up to 116 different time zone combinations. If the Holidays Schedule for Security Levels button
was checked in the Holiday Schedule window, then Time Zone 4 (TZ4) becomes the Holiday time zone and will
show as HOL on the screen. CAUTION: The HOL time zone overrides all other time zones within the security
level.
Anti-Pass Back – If anti-pass back is in use, residents with security levels 02 through 27 will be limited by APB as
well as the usual time, day and relay limitations set up in the security level assigned to them. Security levels 01,
28, 29 and 30 are not limited by APB.
Leave the FLOORS buttons (1-64) blank when elevator control is not being used. If elevator control is in use,
refer to Section 3.8 for additional programming information.
Figure 24
Page 34 1835-066-N-7-13