DoorKing Remote Account Manager - Manual (Page 29)

3.2.1 Labeling Relays with Tracker Disabled
Click the RELAYS button on the tool bar to bring up the relays screen. The relay screen is where the output
relays of the telephone entry system can be labeled, where you will set the relay strike time for the relays, and
where you can enable the "Hold Open During Modeming" command.
NOTE: The "Hold Open During Modeming" command is not active if RS-232 communication is being used.
Use the following instructions if the TRACKER button (System Info Screen) is not checked. If the TRACKER
button is checked, go to section 3.2.2.
1. From the SYSTEM INFO screen, click the RELAYS button in the tool bar. The relay information
screen will appear (fig 16).
2. Clicking the "Hold Open During Modeming" button activates the relay during the data transfer, and
then deactivates it when the data transfer is complete. This will cause your gate or door to remain
open during the data transfer. If this is not desirable, do not activate this feature. The wiegand input
devices (cards, transmitters, etc.) remain operational during the data transfer. NOTE: This feature
is not active when using RS-232 communications.
3. Click in the name field, then enter a name for the relay. This is the name that will appear on the
transaction reports, for example: "Main Gate" or "Side Gate". The maximum characters that can be
entered in this field is 12 (Fig 17).
4. Click the time field and enter the time in seconds that the relay is to be activated.
5. When complete with this screen, click OK to return to the System Info screen.
6. Click the RESET button to change the relay options to the default settings.
7. Clicking the CANCEL button will reset this screen to the previous settings and return you to the
System Info screen.
NOTE: Relay 0 is not used with the 1834 or 1838 system. Leave this field blank if the account that you are
programming is one of these units.
Figure 16 Figure 17
1835-066-N-7-13 Page 29