Nova-Tech pH 110 - Manual (Page 12)

Instruction Manual CyberScan pH 11 / 110
8
1. Align the flange of the second electrode holder with the slot of the first holder
(Figure 8).
2. Slide the flange of the second holder into the slot of the first holder until the
tops of the holders are aligned and secure.
3.2.5 Insert the electrode into the holder
1. Do not use excessive force
when inserting electrodes into
the holders.
2. Insert the pH electrode into the
opening of the first holder until
the top housing of the electrode
touches the top of the holder.
3. If you are using a separate
temperature probe, insert the
probe into the opening of the
second holder until the ridge on
the housing touches the top of
the holder.
NOTE: The holder is designed for
probes 12 mm in diameter. Electrodes larger than 12 mm may not fit in the holder.
Forcing the electrode into the opening may damage the holder or your electrode.
The electrode holders can be attached in different positions for greater flexibility in
measurement and storage purposes. Simply slide out the electrode holders and
reorient into appropriate orientation before putting into position.
Figure 8: To attach a second electrode holder
Figure 9: Different positions for one hand operation
http://www.novatech-usa.com/Products/Laboratory-Equipment-Supply-Products Tel: (281) 359-8538 Toll Free:(866) 433-6682