Nova-Tech pH 110 - Manual (Page 29)

Instruction Manual CyberScan pH 11 / 110
25
8.2.1 Print Current Data Manually
To manually print any data that is currently being
measured:
1. From measurement mode, press HOLD key to
freeze reading. See Figure 24.
2. Print PRINT ( ) key.
3. The “Prn – CUr” annunciator will appear and
flash for about 0.5 seconds. The data is
transmitted to the printer or computer.
4. The meter returns to measurement mode.
5. Repeat steps 1 to 3 for next measurement.
8.2.2 Print Data on Timed Interval
This feature is useful to automate printing and
downloading ‘live’ measurement values into computer.
The time interval setting can range from 5 to 30
seconds.
1. From pH or mV measurement mode, press
PRINT key.
2. Select “Dat/Cur” screen and press
HOLD/ENTER key.
3. The “Sec 5” screen appears. The default value
is 5 seconds time interval. See Figure 25.
4. Press MI/Ÿ or MR/ź key to set a value suitable for your application.
5. Press HOLD/ENTER key.
6. The meter goes into measurement mode with MEM annunciator flashing.
7. At a pre-set time interval, the screen flashes “Prn/CUr” momentarily (printing
data) and switches back to measurement mode with MEM annunciator
flashing.
8. To stop printing, press PRINT key. The MEM annunciator disappears and the
meter is on measurement mode.
pH
pH
MEAS
MEAS
READY
READY
23.4
23.4
6.55
6.55
ENTER
HOLD
°C
°C
pH
MEAS
READY
HOLD
Flash for 0.5 seconds
23.4
6.55
°C
Figure 24: Print current data
manually
http://www.novatech-usa.com/Products/Laboratory-Equipment-Supply-Products Tel: (281) 359-8538 Toll Free:(866) 433-6682