Nova-Tech pH 110 - Manual (Page 21)

Instruction Manual CyberScan pH 11 / 110
17
5 MEASUREMENT
This meter is capable of taking measurements with automatic or manual temperature
compensation. Automatic temperature compensation only occurs when a
temperature sensor is plugged into the meter. If there is no temperature sensor
plugged into the meter, the default manual temperature setting is automatically 25.0
°C. You can manually set the temperature to match your working conditions using a
separate thermometer.
NOTE: Remove the protective rubber cap or soaker bottle of the electrode before
proceeding with measurement. Take care not to exert too much force as this may
cause damage to the electrode.
5.1 Automatic Temperature Compensation
For automatic temperature compensation (ATC) simply
plug the temperature probe into the meter. The ATC
indicator will light up on the LCD.
NOTE: If you are using a temperature probe, the probe
must be submersed in the liquid you are measuring.
MEAS
ATC
°C
pH 7.05
24.5
Figure 15: ATC indicator
http://www.novatech-usa.com/Products/Laboratory-Equipment-Supply-Products Tel: (281) 359-8538 Toll Free:(866) 433-6682