Calibration and zero/span checks, 7 calibration and zero/span checks -1, Calibration section 7 - manual zero/span – Teledyne 6200A - Sulfides analyzer User Manual

Page 108: Section 7 - calibration, Section 7, 7 calibration and zero/span checks

Advertising
background image

TAI Model 6200A SO

2

Analyzer Operator Manual, 02164, Rev. G

7 CALIBRATION AND ZERO/SPAN CHECKS

There are several ways to check and adjust the calibration of the 6200A. These different methods are
summarized in the following Table 7-1. In addition, all of the methods described in this section can
be initiated and controlled via the RS-232 port, see Section 6.8 for details.

NOTE

If you are using the 6200A for EPA monitoring, it is recommended to follow the

calibration method described in Section 7.8. All other calibration methods,

except in Section 7.6, are also applicable to EPA SLAMS if calibrated under

the proper conditions as explained in Section 7.8.

NOTE

If there are any problems completing any of the following

procedures refer to Section 9.2.8 and 9.2.9 – Unable to Span or Zero

7-1

Advertising
See also other documents in the category Teledyne Equipment: