FEC DSP1500 (SAN3) - Manual (Page 12)

enFORCE SAN Unit Operation Manual
PAGE 6 - 12
Chapter 6: System Operation
6.3.6 Parameter Display Mode
The following data is displayed on the screen in the Parameter Display Mode.
By pressing the [↑] and [↓] buttons, the [D-NO] changes and the value of the data number is
displayed in the [DATA] area.
If [↓] is pressed at the first data number of each parameter number, [PARM] parameter number will
increment by 1.
If [↑] is pressed at the last data number of each parameter number, [PARM] parameter number will
decrement by 1.
「
D-NO」 「PARM」 「DATA」
0 Load digit Number
0 ＳＰ Version
0 Amplifier Version
32 Load Change
32 Distance Offset
D-NO : 2 figure display
００
[↑] / [↓]
buttons
０１
０２
６３
６４