FEC DSP1500 (SAN3) - Manual (Page 45)

enFORCE SAN Unit Operation Manual
PAGE 6 - 45
Chapter 6: System Operation
6.5 Setting Up a Parameter for Returning
It is recommended that, if the return of the press is done with a parameter, use Distance Control.
However, if Target Distance is set to 0 without a return operation, the press will reject because the
Distance Low value is zero (a value less than zero is not possible).
Refer to the following for setting up a Return Parameter. Adjustments can be made according to
the individual application.
D-NO DATA SETTING
００ Press Operation ０００１ (Distance Control＋Return Operation)
１１ Load Low Limit ０
１２ Load High Limit Maximum Load of the Tool
１４ Press Speed Start Load 1 or Maximum Load of the Tool
１５ Interference Check Load Maximum Load of the Tool
１６ Distance Measurement Start Load ０
１７ Part Check Low Maximum Load of the Tool
２０ Distance Low Limit ０
２１ Distance High Limit ２
２２ Target Distance １ (setting to 0 will cause a reject)
２３ Interference Check Distance ３
２４ Press Speed Start Distance ２
３０ Advance Position ON Distance ０
３１ Advance Position OFF Distance ０ (if using Rates, set to maximum)
３２ Return Position ON Distance ０
３３ Return Position OFF Distance ０ (if using Rates, set to maximum)
４０ Slow Start Time ０
４１ 1 St Time High １２０
４２ 2 nd Time High １２０
５０ Slow Start Speed １
５１ Approach Speed １００
５２ Part Search Speed ５
５３ Press Speed ３
５４ Return Speed ５
６０ Approach Distance １０ (may need to set larger for higher speeds)
６１ Load Hold Time ０
６２ Job Start Position ０
６４ Distance Offset ０