FEC DSP1500 (SAN3) User Manual
Page 3
enFORCE
SAN Unit Operation Manual
PAGE 6 - 3
Chapter 6: System Operation
6.1.1 DP2S & DP4S Serial Connection
Connector:
DB-9P (Male)
Mating Connector: DB-9S (Female)
PIN No.
Signal
Signal Description
1
Not
Used
2
ＲＸＤ
Not Used
3
ＴＸＤ
Output data for printer
4
ＤＴＲ
ON
output
(always)
5
ＧＮＤ
Signal ground
6
Not
Used
7
ＲＴＳ
ON
output
(always)
8
ＣＴＳ Connects to DTR signals such as printers
9
Not
Used
The CTS signal needs to be activated in order for the press data to be output. If it
is not activated, the data will be stored in the output buffer (up to 16KB). Once the
buffer is full, the data will be overwritten in a First In-First Out (FIFO) process. The
CTS signal may be connected to the RTS signal if data is to be “dumped” at every
process.
1) Connection for confirming the DTR device
D-SUB 9 PIN D-SUB 25 PIN
ＴＸＤ
3
3 ＲＸＤ
ＲＸＤ
2
ＣＴＳ
8 20 ＤＴＲ
ＧＮＤ
5 7 ＧＮＤ
2) Connection for output in any condition
D-SUB 9 PIN D-SUB 25 PIN
ＴＸＤ
3
3 ＲＸＤ
ＲＸＤ
2
ＲＴＳ
7
ＣＴＳ
8 20 ＤＴＲ
ＧＮＤ
5 7 ＧＮＤ
Communication Protocol
Data Bits
8
Error Control
No
Parity
No
Start Bits
1
Stop Bits
2
Speed
9600bps
DSP1500
DSP1500
Output Device