Gentec-EO S-LINK - Manual (Page 31)

S- LINK User’s Manual Revision 2.4 26
*ST1/
*ST2 To display information about current status.
See table 1
*SSX000 To set to Binary or ASCII mode.
Example:
*SS1000: Binary Mode for channel 1
*SS1001: ASCII mode sends All points
*SS1002: ASCII mode sends 1 out of 2 points
*SS1003: ASCII mode sends 1 out of 3 points
*SS1999: ASCII mode sends 1 out of 999 points ( 999 is the maximum )
*SS2001: ASCII mode sends All points for channel 2
Default value is 0 (Binary mode)
Contact Gentec-eo for Binary mode description.
Note: The PC-Slink will not work properly if you set the Slink to ASCII mode.
*SU1 /
*SU2
To make a physical scale up for channel 1 or 2.
You must stop the continuous acquisition (*CS1, *CS2), before sending this
command.
*SD1 /
*SD2
To make a physical scale down for channel 1 or 2.
You must stop the continuous acquisition (*CS1, *CS2), before sending this
command.
*ET1x /
*ET2x
To Set the External Trigger for Channel 1 or 2.
x= 0 = disable, x = 1= enable
Default value is 0.
Example : To disable the External trigger for Channel 1 enter *ET10 .
Example : To enable the External trigger for Channel 2 enter *ET21 .
You must stop the continuous acquisition (*CS1, *CS2), before sending this
command.
*EM1x /
*EM2x For Power heads only. To set the energy Mode to Channel 1 or 2.
x= 0 = disable, x = 1= enable
Default value is 0.