Appendix b, Ecycling and separation procedure, Eparation – Gentec-EO S-LINK User Manual
Page 54: Ismantling procedure
S-
LINK User’s Manual Revision 2.4
49
6
Appendix B
6.1 Recycling and separation procedure.
This section is used by the recycling center when the monitor is at the end of its life. Breaking the
calibration seal or opening the monitor will void the S-Link warranty.
The complete Monitor contains
1 Monitor
1 USB cable
1 Instruction manual
1 Calibration certificate
1 Software cdrom
The Ethernet option contains:
1 power supply (ordered separately) (not manufactured by Gentec-eo)
2 Ethernet Cables.
6.2 Separation:
Paper: Manual and certificate
Aluminum: Monitor enclosure.
Printed circuit board: inside the monitor.
6.3 Dismantling procedure:
To open the monitor:
Remove all the screws on both sides of the monitor:
Remove the PCB by sliding it out of the enclosure.