Gentec-EO S-LINK - Manual (Page 45)

S- LINK User’s Manual Revision 2.4 40
Click OK for the Username and password (leave them blank)
Select the “Network” option, do not change any other settings.
Click on “Use the following IP configuration”
Set the IP address to: 192.168.0.2
Set the subnet Mask to: 255.255.255.0
Click OK, then Click on Apply Setting
The S-link will reboot itself. Since the IP has changed, the Web configuration will lose its
connection. Close the Device installer if th
e Web configuration doesn’t stop trying to make a
connection. To test your configuration you can open a web browser at 192.168.0.2. You should
see the login window. Go to section 6.2. to create a COM PORT. If you wish to change the IP
again, or set it to get an IP automatically, you will have to use a 2-node network again.