Ransburg MMA-303 Direct_Ind Charge Atomizer A12870 - Manual (Page 64)

MMA-303 Direct/Indirect Charge - Operation
61 LN-9269-11.3
PROTECTIVE COVERS
It is recommended to use covers to reduce the
amount of overspray build-up on the shroud
and electrodes. Two covers are available, a
white lint free stretch cloth for covering the
probes and a foam cover (green) for the front
shaping air shroud. The white cloth cover
should cover all of the electrode except for the
last 1-inch (25-4mm). The green foam cover
should be installed until just past the radius
edge of the shroud. Care is to be taken when
installing the white cloth covers over the elec-
trodes, do not bend them. (Devise a fixture to
help slide the cover over easier.).
When cleaning, do not get covers wet, it will
attract more overspray, more quickly. Push
them back, clean surface, dry thoroughly, and
slide back to original position. Depending on
conditions, covers should be replaced after
each shift (8 hours).
A11565-00 White Stretch, Lint Free Covers
A11564-00 - Foam Elastic Covers (Green)