Ransburg MMA-303 Direct_Ind Charge Atomizer A12870 - Manual (Page 82)

MMA-303 Direct/Indirect Charge - Maintenance
79 LN-9269-11.3
rod into the front hole of the atomizer body
where the cup wash tube exits and push out
the rear ferrule in the atomizer body (see
“Rear Ferrule Removal” figure). Tap lightly if
required to remove ferrule.
DISASSEMBLY PROCEDURES
(Cont.)
Removal of Old Tubing
Rear Ferrule Removal
To Replace Cup Wash Tubing
Install O-ring into manifold as shown in “Install
O-Ring Into Manifold” figure. Using petrolatum
jell on the O-ring will help hold it into place dur-
ing assembly.
Install O-Ring Into Manifold
Slide ferrule (A11305-00) onto tubing with ta-
pered end first as shown in “ Slide Ferrule On-
to Tubing” figure. Install tubing into cup wash
with fitting (A11276-00) as shown in “ Fitting
Tool Fully Engaged” figure. Tubing should in-
sert into fitting approximately 0.25-0.31-inches
(6-8mm).
Slide Ferrule Onto Tubing