Ransburg MMA-303 Direct_Ind Charge Atomizer A12870 - Manual (Page 80)

MMA-303 Direct/Indirect Charge - Maintenance
77 LN-9269-11.3
DISASSEMBLY PROCEDURES
(Cont.)
Tool/Bell Cup Engagement
Splash Plate Removal
After removing the bell cup from the applicator,
put it on a plastic or wood surface to prevent
damage to the edge of the cup. Using the
splash plate removal tool (A11388-00), insert
the small end of the tool into the end of the
splash plate assembly. Press the splash plate
out. It may be necessary to tap lightly with a
hammer.
!
C A U T I O N
•
Failure to replace a damaged bell cup will
cause vibration of the applicator and/or
premature turbine failure.
Splash Plate Insertion (55mm and 65mm
Bell Cups)
Turn the splash plate removal tool over and
use the large diameter end to press the splash
plate back in place by hand. It may be neces-
sary on occasions to use an arbor press to
install the splash plate. Press splash plate to
a hard stop (see “Splash Plate Insertion” fig-
ure).
Splash Plate Insertion
A11968-01/02 Bell Cup and Splash Plate
Assembly
Splash Plate Removal
After removing the bell cup from the applicator,
put it on a plastic or wood surface to prevent
damage to the edge of the cup. Using the