Ransburg MMA-303 Direct_Ind Charge Atomizer A12870 - Manual (Page 74)

MMA-303 Direct/Indirect Charge - Maintenance
71 LN-9269-11.3
MMA-303 PREVENTIVE MAINTENANCE SCHEDULE (Continued)
Frequency (Maximum)
Procedure Mid-Shift End of Shift Weekly 2 Monthly 3 Months 6 Months Yearly
Inspection of Electrode X
Replace Electrodes X
Inspection of Tubing Bun- X
Regrease Tubing Bundle X
Replace Tubing Bundle X
Replace High Voltage Ca- X
Inspect Turbine Spindle X X
taper and threads
Replace Bell Cups X X X
Replace Splash Plates X X
Inspect and Clean Spindle X X
Bore and Fluid Tube OD
Check High Voltage Con- X
area for damage/arcing
Inspect for Fluid Leaks Daily
Check Exterior of High X
Voltage Ports for degrada-
tion
Check External Cup Flush X X
Carbide Tip for blockage
N O T E
NOTE - The outer protective cover may have
to be replaced more frequently than weekly.
Daily inspection of the amount of paint build-
up on the cover will determine the frequency of
replacement.
DISASSEMBLY PROCEDURES
N O T E
For reassembly instructions, use the reverse
of the following disassembly procedures.
To facilitate atomizer removal from hose mani-
fold, a robot program should be made that
purges all paints and solvents from the MMA-
303. Ideally it would then position the bell as-
sembly in a bell removal position where the
bell cup is pointed downward at a 30° angle.