AT&T 8434 - Manual (Page 20)

Resetting the Speakerphone with the Softkeys
(When Powering Up the Voice Terminal)
When you first power up the voice terminal, the following display appears.
PLEASE RESET SPKR.
Begin Cancel
When you reset the speakerphone on your voice terminal, you hear a set of tones as
the speakerphone performs an acoustic test of the environment. When the tones
stop, your speakerphone has finished adjusting itself for optimal performance and is
ready for use. For more information about the Reset Speakerphone feature, see
“Reset Speakerphone” in the section Voice Feature Procedures later in this guide.
To reset the
speakerphone (when the
voice terminal is first
powered up) 1 Press the softkey below Begin to reset the
speakerphone
(Press the softkey below Cancel if you do not want
to reset the speakerphone at this time. However,
note that the red light next to [
Speaker ] will continue
to flutter.)
• If you press the softkey below Begin, the display
shows the following timed screen:
OPTIMIZING PERFORMANCE
OF THE SPEAKERPHONE.
• You will hear a set of rising tones as the
speakerphone adjusts itself to the surrounding
acoustical environment. These tones are
automatic. No user response is required.
15