AT&T 8434 - Manual (Page 37)

•
•
The display shows the number of the ringing
pattern you have selected
Red light next to [ Shift ] goes off
Note: If you receive a call, go off-hook, or lose power
during selection, the process is interrupted and you
must start again.
To adjust ringer volume
if necessary (speaker is
not active)
1 To raise the volume, press the right half of the
Volume control button labeled
to lower the volume, press the left half of the Volume
control button labeled
• The display shows:
RINGER L > > > > H
(There are eight possible volume settings. On the
display, one arrow is the lowest setting, and eight
arrows is the highest setting)
One full ring cycle will sound to demonstrate the
new volume
Send All Calls
You can access this feature with the softkeys only if the feature’s abbreviation, SAC,
appears on the second line of one of the feature option screens.
To send all calls (except
priority calls)
immediately to coverage
(If your system manager
has provided a coverage
path for your extension)
1 While on-hook, press [ Menu ] and then press the
softkey below SAC
or, if SAC is not available on your display,
press [ Send Calls ] (while on-hook)
or Dial Send All Calls access code
(while on-hook)
[confirmation tone]
Note: You may hear a ring-ping tone from your
voice terminal as each call is forwarded.
To cancel Send All Calls 1 While on-hook, press [ Menu ] and then press the
softkey below SAC again
or, if SAC is not available on your display,
press [
Send Calls ] again (while on-hook)
or Dial Send All Calls cancel code
(while on-hook) [confirmation tone]
32