AT&T 8434 - Manual (Page 22)

3
4
Press [ Menu ] and then press the softkey below Prog
or, if Prog is not available on your display,
press [
Program ]
or Dial AD Program access code
[dial tone]
Press [ AD xxxxx ] to be programmed [dial tone]
5
6
Dial outside number, extension, or feature access
code you want to store (up to 24 digits)
Note: You may also be able to use the softkeys to
add special functions such as Pause, Mark, Wait, or
Suppress into the telephone numbers programmed
on the AD button.
If you are programming an outside number, be sure
to include a trunk code, if applicable.
Press [ # ] [confirmation tone]
•
•
Number is stored
Repeat Steps 4 through 6 to program additional
buttons
Hang up or press [ Drop ] to end programming 7
To place an AD call 1
2
Press selected [ AD xxxxx ] [ringback tone]
Call is automatically dialed
To program/reprogram
an outside number,
extension, or feature
access code into a
personal list 1
2
3
4
On a separate sheet of paper, write down the outside
numbers, extensions, and/or feature access codes you
want to program as items on your personal lists(s)
Note: Each phone number or feature access code is
stored as a separate item.
Pick up handset
Note: If you are using the built-in speakerphone,
[dial tone]
you must either press a call appearance button or
press [
Speaker ] before you begin Step 3.
Press [ Menu ] and then press the softkey below Prog
or, if Prog is not available on your display,
press [
Program ]
or Dial AD Program access code
[dial tone]
Dial Personal List number (1, 2, or 3)
[dial tone]
17