LEDGlow Million Color LED Wheel Well Kit - Manual

Million Color LED Wheel Well Lighting Kit
Warning: Please check your state and local laws before installing this Million Color LED Wheel Well Kit. Every state has
different policies and procedures in place regarding aftermarket vehicle accessories. LEDGlow is not responsible for any fines
that you may receive while using this lighting kit. This kit is for off road use only.
Warning: The installation of this kit is recommended to be installed by a licensed professional. The improper installation of this
kit will void all warranties.
The Control Box and Junction Cable that are used to power the wheel well tubes must be installed in a dry location!
Having these parts exposed to water or the elements will cause the kit’s controller to fail. Any water damage or corrosion
to this part will VOID all warranties.
PLEASE READ THE FOLLOWING INSTRUCTIONS THOROUGHLY BEFORE INSTALLING AND OPERATING
THIS LED WHEEL WELL LIGHTING KIT.
Wheel Well Lighting Kit Includes:

(4) 24 Inch Flexible Tubes

(1) Control Box

(1) Junction Cable

(30) Self Tapping Screws

(20) Zip-Ties
Wheel Well Lighting Kit Installation:
1. Arrange the tubes out on the ground and test the kit to ensure proper functionality before installing. Please refer to the
schematic below for proper placement of the tubes, control box and junction cable.
2. Optional: Raise and support the vehicle if necessary. Remove the vehicle’s wheels if necessary.
3. Start with the driver’s side tube and mount it with plenty of clearance from any heat sources, suspension and moving
parts. The flexible tube can be contoured and mounted on top of the wheel or behind the strut with the included self-
tapping screws.
4. Repeat Step #3 for the remaining 3 tubes. It is extremely important to ensure that the tubes do not come in contact with
any heat sources, suspension and/or moving parts.
5. If you removed the vehicle’s wheels, you can now reinstall them in accordance to factory specifications.
6. After the tubes have been mounted and the wheels have been reinstalled back in place, turn the steering wheel all the
way to the right and left several times to ensure the tubes do not come into any contact with the wheels or any moving
parts. If there is clearance between the tube and wheels, you may resume the installation.
7. Find a safe, secure and dry location to mount the control box. The control box was not designed to withstand water or
the elements. We recommend mounting the control box inside of the vehicle and running the distributor cable through
the firewall. If this is not possible, you can mount the control box in the engine compartment in the driest location
available. Water damage and/or corrosion to the control box will void all warranties.