LEDGlow 4pc Classic Single Color Starter Motorcycle Kit - Manual

2-4pc Classic LED Motorcycle Light Kit
Warning: Please check your state and local laws before installing this Motorcycle Lighting Kit. Every state has different policies and
procedures in place regarding aftermarket LED lighting accessories. LEDGlow is not responsible for any fines that you may receive
while using this lighting kit. This lighting kit is for off road use only.
Warning: The installation of this kit is recommended to be installed by a licensed professional. The improper installation of this kit
will void all warranties.
The power switch that is used to power the lighting strips must be installed in a dry and accessible location! Having this part
exposed to water or the elements will cause the power switch to fail. Any water damage or corrosion to this part will VOID all
warranties.
It is recommended to install each motorcycle lighting strip using 3M™ Adhesion Promoter which allows for a much stronger bond
between the adhesive tape of the lighting strip and the cleaned mounting surface of your motorcycle. This is an optional installation
accessory that is NOT included with your motorcycle lighting kit.
PLEASE READ THE FOLLOWING INSTRUCTIONS THROUGHLY BEFORE INSTALLING AND OPERATING THIS
LED MOTORCYCLE KIT.
Motorcycle Kit Includes:

Motorcycle LED Lighting
Strips

(1) Power Switch

Wire Harness

Zip Ties
Motorcycle Kit Installation:
1. Upon receiving your new motorcycle lighting kit, we ask that you first test the kit to ensure it is functioning properly.
Connect the white stripe power wire to the positive terminal of the battery and the black ground wire to the negative
terminal of the battery. Once the wires are temporarily secure, power the kit to ensure full functionality before installing it.
If everything appears to be working correctly, turn the kit off and disconnect the power and ground wires from the battery
to prepare for installation.
2. Optional: Remove any trim pieces from your motorcycle that may hinder the installation of the lighting strips.
3. Begin by first laying out the LED lighting strips similar to the way they will be installed. Make sure that the wires will be
able to be routed in such a way that they will not be pinched, cut or exposed to heat. Also, keep the wires and strips away
from all moving parts that may come in contact with any part of the kit. IF A POWER WIRE IS PINCHED, IT WILL
CAUSE THE KIT TO MALFUNCTION AND WILL VOID THE WARRANTY DUE TO PHYSICAL DAMAGE.
4. The power switch is NOT waterproof, so it must be mounted in a dry and accessible location.
5. Temporarily place the lighting strips to their intended mounting locations and route the power wires to the planned power
switch mounting area. Use the supplied zip ties to secure the wires to their mounting points. Be sure to keep the power
wires away from the suspension, any direct heat sources and/or moving parts. A few recommended locations on your
motorcycle to mount the light strips are under the gas tank, lower frame rail, rear fender frame rail, triple trees, lower swing
arm, and under the seat.
6. Once the motorcycle lighting strips and wires have been mocked up, clean the proposed mounting surfaces with an alcohol
prep pad. The mounting surface should be between 45 and 85 degrees Fahrenheit to achieve the strongest bonding results
from the double sided adhesive tape. Note: The surface area must be free of all oils, moisture, dirt and wax in order for the
supplied adhesive tape to bond and adhere to the installation surface correctly. Optional: To achieve the strongest bond
between the lighting strips and the motorcycle, you can use 3M Adhesive Promoter, which is sold separately from your kit.
7. Mount each lighting strip to the cleaned and dry surface of the motorcycle by using the supplied 3M tape. Run the wires to
the planned location of the control box and secure the wire to the bike frame by using the included zip ties. Be sure to use
the zip ties, this is a very important step and should not be skipped. Once this step is complete and the lighting strips