LEDGlow Million Color Golf Cart Kit - Manual

Million Color LED Golf Cart Underbody Lighting Kit
Warning:
Please check your state and local laws before installing this Million Color LED Golf Cart Underbody Kit. Every state has different
policies and procedures in place regarding aftermarket vehicle accessories. LEDGlow is not responsible for any fines that you may receive while
using this lighting kit. This kit is for off road use only.
Warning: THIS GOLF CART LIGHTING KIT WAS DESIGNED TO BE POWERED BY A 12 VOLT SYSTEM. IF YOU ARE
RUNNING A 36 OR 48 VOLT SYSTEM, A STEP DOWN TRANSFORMER IS REQUIRED.
Warning: The installation of this kit is recommended to be installed by a licensed professional. The improper installation of this kit will void all
warranties.
The Control Box and Junction Cable that are used to power the underbody tubes must be installed in a dry location! Having these parts
exposed to water or the elements will cause the kit’s controller to fail. Any water damage or corrosion to this part will VOID all
warranties.
PLEASE READ THE FOLLOWING INSTRUCTIONS THOROUGHLY BEFORE INSTALLING AND OPERATING THIS LED
GOLF CART KIT.
Golf Cart Kit Includes:

(4) 24 Inch Flexible Tubes

(1) Control Box

(1) Junction Cable

(1) Wireless Remote

(30) Self Tapping Screws

(20) Zip-Ties
Golf Cart Kit Installation:
1. Arrange the tubes out on the ground the way you plan on installing it and test the kit to ensure proper functionality before installing.
2. Temporarily power your kit with any 12 volt source to ensure it is functioning properly before you move forward with this installation.
Simply connect the red wire to the positive (+) terminal and the black wire to any good bare ground metal source or negative (-)
terminal of the battery. Power the kit on to ensure full functionality. Once you have determined the kit is functioning properly, remove
the power from your kit and begin the installation.
3. Optional: Raise and support the golf cart if necessary.
4. Before mounting each tube, please refer to the schematic below to ensure correct placement and tube direction.
5. Start with the front tube and mount it with plenty of clearance from heat and moving parts. The tube is flexible and can be contoured
incase the undercarriage is not flat. Make sure that the wires are routed away from any moving parts or exhaust. For gas powered golf
carts leave at least 10 inches between the exhaust and the tube. Also, be sure to keep all wires and tubes away from any steering
suspension parts. You can use the provided self-tapping screws and/or zip ties to hold the tubes in place. If you use the provided
screws, use zip ties to secure the tube.