LEDGlow Million Color Golf Cart Kit User Manual
Page 2
6.
Repeat Step #4 for the remaining 3 underbody tubes. It is very important to ensure that all of the wires do not come in contact with
any moving parts and/or heat sources.
7.
Connect the red wire to a 12 volt source. If a 12 volt source is not available because you have a 36 or 48 volt system, then it is
required to use a step down transformer which is available at any electronic store. IF YOU ARE UNSURE, VERIFY VOLTAGE
WITH A MULTI-METER BEFORE CONNECTING THE KIT TO THE GOLF CART.
8.
If you need to extend the power wires, be sure to use a 16 or 18 gauge automotive grade wire. If you are running the power wire to the
battery and must go through metal, use an existing grommet or drill a hole and add a new grommet, which is available at any auto
parts store. Be sure to reinstall the fuse within 6 inches of the power source. If you connect the power wire to a switched 12 volt
source, then it will not remember the previous color and pattern it was last on. If you are running the wire to the fuse block, LEDGlow
recommends that you install the wire using our Expandable Circuit, which is available online a
or at any auto
parts store, as well.
9.
Connect the black wire to a good ground source, grounding block or you can connect it directly to the negative terminal of the battery.
10. Next, mount the junction cable on the golf cart away from heat in a dry location. The junction cable must be mounted away from
moisture and the elements. CORROSION TO THE JUNCTION CABLE WILL VOID ALL WARRANTIES AND MAY
CAUSE CONTROLLER FAILURE.
11. Starting with the rear tubes, run the wires to the dry location of the junction cable. Make sure to secure the wires tightly when going
around any suspension parts and exhaust. Leave at least 10 inches between the exhaust and the wires. Also, be sure to keep all wires
and tubes away from any suspension parts. If a wire is pinched, the kit may malfunction and could void the warranty. Run the wires
along one side of the golf cart and make sure to tightly secure it. Then, run the front tube wires to the junction block.
12. Once again, make sure the wire is mounted away from heat and moving parts. Any excess wire will have to be bound and secured
tightly.
13. DO NOT SHORTEN OR CUT THE WIRES. YOU WILL DESTROY THE KIT AND VOID THE WARRANTY.
14. Lower the golf cart if it was raised, and test your new LEDGlow Million Color LED Golf Cart Underbody Kit.
15. With the golf cart on the ground, turn the steering wheel as far as it can go in both directions to ensure that there will be no tubes
and/or wires coming in contact with the tire as you’re driving down the road. If a tube or wire is damaged by the tire, the warranty
will be voided.
Adding or Replacing your Wireless Remote:
1.
Your kit is already pre-programmed for the included wireless remote. This setup is only needed when replacing an existing remote or
by adding additional wireless remotes to your system. You can program up to 3 wireless remotes to one control box.
2.
In order to program the remote to the control box, you must turn the kit off.
a)
First Remote - Press and hold the mode button on the wireless remote and the mode button on the control box for 5-7
seconds. Test the operation with the remote.
b)
Second Remote - Press and hold the mode button on the wireless remote and the mode button on the control box for 5-7
seconds. Test the operation with the remote.
c)
Third Remote - Press and hold the mode button on the wireless remote and the mode button on the control box for 5-7
seconds. Test the operation with the remote.
For accessories, replacement parts and/or technical support, please visit
for more information.