LEDGlow 7 Color Slimline Truck LED Underbody Kit - Manual

7 Color Slimline Truck Underbody Kit
Warning:
Please check your state and local laws before installing this truck LED underbody kit. Every state has different policies and
procedures in place regarding aftermarket vehicle accessories. LEDGlow is not responsible for any fines that you may receive while using this
underbody kit. This kit is for off road use only.
Warning: The installation of this kit is recommended to be installed by a licensed professional. The improper installation of this kit will void
all warranties.
The control box that is used to power the underbody tubes must be installed in a dry location! Having this part exposed to water or the
elements will cause the kit’s controller to fail. Any water damage or corrosion to this part will VOID all warranties.
PLEASE READ THE FOLLOWING INSTRUCTIONS THOROUGHLY BEFORE INSTALLING AND OPERATING THIS LED
UNDERBODY KIT.
Truck Underbody Kit Includes:

(2) 48 Inch Tubes

(2) 36 Inch Tubes

(2) 24 Inch Tubes

(1) Control Box

(1) Wireless Remote

(16) Underbody Tube Brackets

(20) Zip Ties

(18) Large Screws

Self-Sealing Tape
Underbody Kit Installation:
1. Arrange the tubes out on the ground and test the kit to ensure proper functionality before installing.
2. Temporarily power your kit with any 12 volt source to ensure it is functioning properly before you move forward with the
installation. Simply connect the red wire to the positive terminal and the black wire to any good ground source. Power the kit
and once you have determined it is functioning properly, remove power from the kit.
3. Before mounting the underbody tubes, please refer to the schematic below. The underbody tubes on this kit must be
installed in a specific way. This ensures all lighting patterns are properly synchronized and displayed correctly.
4. Once the kit is laid out and you have determined the kit is functioning properly, you can proceed with the rest of the installation.
5. Optional: Raise and support the vehicle.