LEDGlow 2pc Motorcycle LED Strobe Lighting Kit - Manual

2 Piece LED Strobe Light Kit
Warning: Please check your state and local laws before installing this LED Strobe Kit. Every state has different policies and procedures in place regarding
aftermarket vehicle accessories. LEDGlow is not responsible for any fines that you may receive while using the LED strobe kit. This kit is for off road use only.
Warning: The installation of this kit is recommended to be installed by a licensed professional. The improper installation of this kit will void all warranties.
Please read the following instructions thoroughly before installing this 2 Piece LED Strobe Kit.
Strobe Kit Includes:

(2) LED Strobe Heads

(2) Strobe Wires

(2) External Mounts

(1) ON/OFF Power/Pattern Switch

(1) Flange Kit
Powering the Kit
1. Prior to installation test this LED strobe kit to ensure it is functioning properly by simply connecting both of the LED strobe lights to
the power harness, then connecting the red and yellow wires to the positive (+) terminal on the battery, as well as connecting the black
wire to the negative (-) terminal on the battery or to an unpainted metal ground source. Once you have determined the kit is
functioning properly you can proceed with the installation.
2. Using 16 or 18 gauge automotive grade wire, run a lead power wire from the positive (+) terminal on your battery to the pin 1 (the
lower pin) on the red side of the included rocker switch. Be sure to install an inline fuse within 12 inches of your battery.
3. Connect the RED wire from the controller’s lead power wire to pin 2 (the upper pin) on the red side of the included rocker switch.
4. Connect the YELLOW wire from the controller’s lead power wire to pin 2 (the upper pin) on the black side of the switch.
5. To power the black button on the rocker switch, which allows you to change patterns, connect a 16 or 18 gauge jumper wire to pin 2
(the upper pin) on the red side of the rocker switch to pin 1 (the lower pin) on the black side of the switch.
6. Note: The WHITE wire on the controller’s lead power wire is not used unless you are installing more than one Strobe Kit.
Optional: The following instructions are for powering two 2 Piece LED Strobe Kits to one switch. To complete this installation you may
need to extend the wires. If so, be sure to use 16 or 18 gauge automotive grade wire. If you are just installing one kit, continue to the
mounting portion of the instructions.
1. Connect the WHITE wire on Controller 2 to the RED wire on
Controller 1.
2. Connect the RED wire on Controller 2 to the RED wire on
Controller 1.
3. Connect the YELLOW wire from Controller 1 to the
YELLOW Wire on Controller 2
4. Connect the BLACK wire from Controller 2 to an unpainted
metal ground source.
Mounting the Strobe Lights into Your Existing Headlight Assembly
1. Drill a one inch hole, and snap the lights into place. Use silicone
to seal the hole and prevent water from getting into your
headlamp.
Surface Mounting the Strobe Lights Using the Flange Kit
1. Using a Phillips Head screwdriver, remove the two screws and
the round silver ring from the back of each strobe light.
2. Using the two screws you just removed, install the oval silver
flange plate to the back of the each strobe light
3. Drill a 7/8th inch hole where you plan on mounting each light
for the wire to pass through and a flush mount.
4. Place the foam gasket between the oval plate and the mounting
surface for a tight seal.
5. Place the black oval trim ring on top of each light and screw in
the strobe, oval trim, and rubber seal using the supplied screws.
Operating the Kit
1. Flip the red switch to the on position to turn the strobe lights on
2. Press the black switch to cycle through all 18 Patterns.