LEDGlow 8pc Truck Bed Lighting Kit - Manual

8pc Truck Bed LED Lighting Kit
Warning: Please check your state and local laws before installing this Truck Bed Lighting Kit. Every state has different policies
and procedures in place regarding aftermarket LED lighting accessories. LEDGlow is not responsible for any fines that you may
receive while using this lighting kit. This kit is for off road use only.
Warning: The installation of this kit is recommended to be installed by a licensed professional. The improper installation of this
kit will void all warranties.
It is recommended to install each lighting strip using 3M™ Adhesion Promoter which allows for a much stronger bond between
the adhesive tape of the pod light and the cleaned mounting surface of your truck bed.
PLEASE READ THE FOLLOWING INSTRUCTIONS THOROUGHLY BEFORE INSTALLING AND OPERATING
THIS TRUCK BED LIGHTING KIT.
Truck Bed Lighting Kit Includes:
 (2) Strands of 4 Pod Lights
 (1) On/Off Switch
 (2) Female Spade Connector
 (16) Screws
Truck Bed Lighting Kit Installation:
1. Prior to installation, clean the proposed mounting areas with soap and water, then wipe down with alcohol and allow
time to dry.
2. Arrange the lights in your truck bed the way you plan on installing them. You can refer to the schematic below for the
ideal placement of each pod light. Be sure there is enough space under the bedrail or tonneau cover to mount each pod
light. If the strand of lights is too long, gather
the excess wire between the pods and secure
them with zip ties. Note: Do not cut the
wires between each pod in order to shorten
them. This will void ALL warranties.
3. Once you have determined the locations
where you want to mount each pod, you can
mount each pod light to the cleaned surface
of your bedrail. Be sure to press firmly on
each pod to ensure it is secured. Optional:
To achieve the strongest bond between the
pods and the mounting surface of the bedrail,
you can use 3M Adhesion Promoter which is
sold separately from your kit.
4. Route the power wires from both light
strands through the truck bed and into your
cab using an existing hole with a rubber
grommet. If you do not have an existing hole
in your cab, you can drill a new hole to pass the wires through. Note: If you are drilling a new hole, be sure to install a
rubber grommet to ensure the metal does not cut the power wires over time.
5. Connect the 16 or 18 gauge automotive grade wiring to a positive 12 volt source. You can connect the wire to the
positive terminal of the battery or at any 12 volt source in the fuse box using LEDGlow’s Expandable Circuit, which is
sold separately from your kit. Note: Be sure to install a 5 amp inline fuse 5-8 inches from the power supply. If you
would like the truck bed lights to turn on without your truck being on, connect this power wire to a constant 12 volt
source.