LEDGlow 4pc Classic Single Color Starter Motorcycle Kit User Manual
Page 2
and wires are secure, allow ample time for the adhesive to settle and cure. Repeat this step for the remaining strips included
with your kit.
8.
Route the white stripe power wire from the power switch to the positive terminal of the battery and the black ground wire
to the negative terminal of the battery. If the wires need to be extended, use automotive grade, 16-18 gauge wire for the
power and ground wires only. Connect and secure the power supply lines only after everything is properly installed and
mounted. If you do not follow this step, the inline fuse on the white stripe power wire may blow.
9.
The kit was designed using a modular locking plug system for connecting the motorcycle lighting strips to the power
switch by using the included wire harness. Start plugging the male connections from the strips and power switch into the
female connections of the harness. Secure the excess wires of the strips and harness to the frame of your bike using the
included zip ties. DO NOT CUT OR SHORTEN ANY WIRES, YOU WILL VOID THE WARRANTY.
10. If you removed any trim for this installation, you can now reinstall them and test the functionality of your kit by pressing
the power switch.
11. Expandability: This kit includes a 6pc wiring harness that allows an additional 4 LED lighting strips to be added to a 2pc
kit or 2 additional LED lighting strips to a 4pc kit for even further customization.
12. For more information, please refer to our instructional videos that can be found a
Troubleshooting:
If the kit or lights do not appear to operate, first check the installed inline mini fuse.If the fuse is blown, check the wires on
the entire kit to ensure they are not cut, pinched or scorched. If there is no damage to any of the wires and no water damage is visible
to the power switch, replace the fuse and test the kit again. If the fuse is intact, clean the battery terminals, both the positive and
negative terminals. Corrosion to the battery terminal can cause a poor connection or simulate being disconnected.
For accessories, add-on kits, replacement parts and/or technical support, please v
or more information.