Teledyne LeCroy SierraNet M168 User Manual Ver.1.50 - Manual (Page 224)

Teledyne LeCroy Scenario Example
222 SierraNet M168 Protocol Analyzer User Manual
5. Select Replace DWORD in the Action panel and place it in the Global Rules panel
(see Figure 4.18 on page 222 ).
6. Right‐click the New Scenario 0 tab and select Rename and enter the name in the
Library panel as shown below.
Figure 4.18: Global Rules
Adding a Sequence
To add a Sequence click Add State in the Sequence 1 panel.
You create a sequence one state at a time. The application numbers states consecutively
from 0 up (1, 2, 3, and so on).
By default, the name of the first sequence in a Scenario is Sequence 1. The name of the
first state is State 0. To change the name of a sequence or state, or to associate a
description with it, click the name of the sequence or state..
1. Drag 6‐Byte Any SCSI Command under FCP as the Event to display the dialog.