7 protocol analyzer – Teledyne LeCroy SierraNet M168 User Manual Ver.1.50 User Manual
Page 34
![background image](/manuals/353534/34/background.png)
Teledyne LeCroy
Protocol Analyzer
32
SierraNet M168 User Manual
Figure 1.25: Info Dialog
Then the update is complete. The connection may freeze when the unit reboots after the
firmware update. Perform the following steps to recover:
1. Click OK on the error message in the Info dialog.
2. Click Close to close the Device Setup dialog.
3. Click Refresh Device List in the Device Management dialog (see
).
4. Click Disconnect.
Figure 1.26: Device Setup Dialog with OK Device Status
Note:
Do not shut down or power cycle the analyzer during this process.
1.7 Protocol
Analyzer
To use the software for protocol analysis, first select File > New Project for a new project
or File > Open to open an existing protocol analysis .gep file. (see
) You can also open a .get
example file. Example files are in the Examples folder.
You can also select File > Recent Projects to open a project you had recently saved.