Teledyne LeCroy SierraNet M168 User Manual Ver.1.50 - Manual (Page 64)

Teledyne LeCroy Trigger and Filter Settings in Easy Mode
62 SierraNet M168 User Manual
 Capture different patterns pre‐ and post‐trigger (see “Patterns and Data Capture
Setup” on page 65 ).
 Exclude parameters from capture (see “Patterns and Data Capture Setup” on
page 65 ).
 Trigger on a pattern or sequence of patterns (see “Trigger Setup” on page 131 ).
 Configure trace capture memory
 Select file to save trace capture in memory
Saving a Trace Capture
You can save a Trace Capture for review at a later time using the Save As dialog.
Figure 2.36: Save As Dialog
You can limit the range of the saved file. You can save:
 All Packets
 A range between selected cursors
 A range between selected level of decoding. The levels allowed are dependent
on the traffic in the trace. A trace with only Switch traffic might have the follow‐
ing levels available: ELS Cmd, Frame, GS Cmd, Sequence and SW Cmd, whereas a
read‐write trace might have Frame, SCSI Cmd and Sequence available.
Only Save Displayed Events: Click the checkbox to save only the Filtered in data in the
trace.