Teledyne LeCroy Sierra M6-4 SAS_SATA Protocol Analyzer User Manual - Manual (Page 182)

Teledyne LeCroy Target and Device Emulation
180 Sierra M6‐4 SAS/SATA Protocol Analyzer User Manual
Alternate Display Format
You can display the result as 2D, 3D, and so on, by clicking the corresponding Graphics
Setting on the Performance Analysis toolbar.
2.5.3 Run Hardware
To perform the defined analysis, click the Run Hardware button and wait for the
result to display.
2.6 Target and Device Emulation
You can run the analyzer while device emulation is active to monitor bus traffic.
2.6.1 Pages Tab
SAS: To set up SAS Target Emulation, click File > New > SAS Target Emulator to display the
target emulator with the Pages tab selected (see
Figure 2.173 on page 179 ).
Area Chart
Columns and Bar Chart
Line Chart
Pie Chart
Switch between 2D and 3D
Show/Hide Legend Window
Grid lines On/Off