Teledyne LeCroy Sierra M6-4 SAS_SATA Protocol Analyzer User Manual - Manual (Page 82)

Teledyne LeCroy SAS/SATA Software Menus and Toolbars
80 Sierra M6‐4 SAS/SATA Protocol Analyzer User Manual
Vendor
Vendor is for FIS Pattern.
Figure 2.36: FIS Pattern - Vendor Dialog
2.2.30 Trigger Setup
The Trigger tab in the analysis project dialog allows you to specify when the analyzer
completes a data capture. Three trigger modes are available:
 Don’t care (Snapshot) is the default
 Manual Trig
 Pattern
When data capture starts with Don’t care (Snapshot) selected, the analyzer triggers on
the first data pattern on the bus.
Starting a data capture with Pattern selected triggers when specific pattern(s) are
detected in the captured data stream. The following three methods can trigger the
analyzer with Pattern selected.
 Trigger on any pattern (Any Trigger Mode)
 External Trigger
 Trigger on a sequence of patterns (Sequential Trigger Mode)