Teledyne LeCroy Sierra SAS_SATA Protocol Analyzer STX API Reference Manual - Manual (Page 139)

Sierra SAS/SATA Protocol Suite, STX Software API Reference Manual
Using Trainer 139
Using Trainer
Using a Trainer API is a bit different from using APIs of Analyzer or Host/Target Emulator.
This section discusses:
• Setup your Trainer API application
• Initialize the application
• Connect to the board
• Start Trainer
• Stop/Resume Trainer
• Summary
Create and Setup your API Application
First create your New API Application.
(If using VC++ , create MFC Application as Single Document Type and check
Document–View Architecture support.)
Note: Browse the project creation path to the \APIExamples\Trainer_API\ folder of the
SAS/SATA Installed directory or STX Software directory.
Next import the required DLLs into your application by adding the code below at the end of the
stdafx.h.file of your project .
#import "..\..\..\..\EXE\CEIEnums.dll"
using namespace CEIENUMSLib;
#import "..\..\..\..\EXE\CEIStorageEnum.dll"
using namespace CEISTORAGEENUMLib;