Agilent Technologies Wireless Network Optimization Platform E6474A - Manual (Page 17)

Installing the Software 2
Agilent E6474A User’s Guide 17
Install Analysis Reporter software
The Analysis Reporter (Agilent E6474A- 758) option is a
simple to use post- processing report tool. You must have
purchased the E6474A- 758 option to run this software.
Follow these steps.
Do This Notes
1 Insert the Agilent E6474A CD. This CD contains the required
software device drivers.
2 Your system may have autostart or go to
the Start button, click Run and type D:\
setup (where D is your CD drive).
The installation dialog box
appears.
3 Follow the installation instructions If you have a previous version
installed on your PC your will be
prompted to over-write it with
the newer version.
4 Select the Analysis Reporter installation
option
See below, Figure 2 on page 18.