Agilent Technologies Wireless Network Optimization Platform E6474A - Manual (Page 38)

38 Agilent E6474A User’s Guide
3 Set Up Your System
Follow the manufacturer’s instructions for installing the
pulse trigger device. Connections to the receiver are shown
in
Figure 17 .
• If you have two receivers, connect the pulse trigger cable
(E7450- 60015) to the R X L OOP I N and R X L OOP O UT ports
as shown in Figure 17 .
• Or, if you have one receiver, connect the pulse trigger
cable to the R X L OOP I N and R X L OOP O UT ports of the
same receiver.
• Connect the cable from the pulse trigger device to the
BNC connector of the pulse trigger cable. For software
configuration and calibration instructions, refer to the
online help. Search for “wheel pulse unit setup” to locate
the information.
Figure 17 Connecting the pulse trigger cable