Agilent Technologies Wireless Network Optimization Platform E6474A - Manual (Page 186)

186 Agilent E6474A User’s Guide
D Permanent In-Vehicle Hardware Installation
Figure 114 E6474A positioned on mounting plate
To attaching the receiver to the mounting plate
1 Slip one end of the receiver under the latch tab.
2 Slide the receiver into place.
To detach the receiver
1 Pull the latch tab to release it.
2 Lift the receiver up approximately one inch (25mm), then
slide the receiver forward and lift out.
Installing the PDM in the Vehicle
1 Locate a flat surface of the vehicle to which the PDM can
be securely attached. Refer to Figure 115 on page 187.
2 Mark the holes for the #12 mounting screws on the
mounting surface according to the hole pattern of the
PDM.
Latch tab
RF IN
GPS
1PPS
9-34VDC
Agilent W1314A-120
Quad Band Receiver
GPS
ANT