Agilent Technologies Wireless Network Optimization Platform E6474A - Manual (Page 182)

182 Agilent E6474A User’s Guide
D Permanent In-Vehicle Hardware Installation
WARNING
• Before installing this product, check your vehicle warranty for
any special instructions regarding the installation of third party
products. Agilent assumes no responsibility for any vehicle
warranty issues arising out of the installation or use of this
product.
• It is recommended that any vehicle installation should be done by
a qualified vehicle mechanic and electrician.
• Choose suitable locations for the W1314A and any accessories
you install to avoid interfering with the operation of the vehicle,
but that will allow access to the cable connectors. Be sure to
allow room for the mounting plate.
• Observe local regulations and restrictions when installing the
equipment and making electrical connections to the vehicle.
• Use caution when drilling holes and working around critical
areas such as the fuel tank, fuel lines, battery, engine
compartment, electrical harnesses, fuse block, and the exhaust
system.
• Disconnect the battery before making permanent connections to
the electrical system.
CAUTION
• Secure all components to prevent movement while the vehicle is in
motion.
• When routing cables, leave sufficient length on both ends for
making connections. Avoid sharp metal edges, sharp bends, and
crushing the cables. Use a rubber grommet if the cable is routed
through a hole in a metal panel. Do not route a cable near the
catalytic converter. Use wiring troughs when they are available.